Shipwreck Patina Benchmade Bugout – Brass Backspacer
**YOU WILL ONLY RECIEVE ONE BACKSPACER AND TWO STANDOFFS**
**TWO SHOWING JUST FOR PICTURES**
***Shipwreck Patina Finish***
The shipwreck patina will naturally change based on usage, it is like a living finish that will continue to evolve due to dirt and oils on your hand and in the environment. I do apply a clear coat to seal the patina before engraving the scales, but you can do an additional clear coat to double up on it. Any clear coat will work and you can apply as often as you want.
Patina finish, solid brass construction. Fits both stock and Flytanium Bugout scales.
*Knife not included. Uses hardware from stock knife.
You may need two torx bits to tighten each screw in the spacers.
Installation of the backspacer requires some basic tools and knowledge. You will need a high quality Torx bit set to remove the screws and pivot.
Please Note: Benchmade’s Warranty does not cover disassembly of any knife by any person other than Benchmade’s Warranty department.
Reviews
There are no reviews yet.