Spyderco Slotted Manix 2 Ball Cage Lock – Titanium – Flytanium Gear

See our full selection of FLYTANIUM GEAR on our website:
https://www.dnalasering.com/product-category/aftermarket/

Flytanium TI Slotted Ball Cage Lock for Spyderco Manix 2

– Titanium construction
– Will fit both Spyderco Manix 2 and Manix 2 XL models
– Will NOT fit Manix 2 Lightweight, Manix 2 Cru-Carta C101MPCW2, and CRU-WEAR Models
– Weighs 0.08 oz

Because each knife is slightly different, there is a break-in period following installation. Spend some time opening and closing your knife, enjoying your new lock, and you’ll be good to go!

*Installation of the ball cage lock requires some basic tools and knowledge. You will need a high quality torx bit set to remove the screws and pivots. The pivot and lanyard tube can be tough to remove. There are some good informational videos on YouTube if you need more instructions.

Disclaimer: There are many small parts and pieces on the Manix 2. It is NOT easy to take apart. Disassemble at your own risk.

*Please Note: Spyderco’s Warranty does not cover disassembly of any knife by any person other than Spyderco’s Warranty department.